Drive Unit Bearing 6307/C3

Price:

£ 6.00


CCS Type 2 Fast Charging Kit
CCS Type 2 Fast Charging Kit
£ 3,300.00
£ 3,300.00
Orion 2 BMS - 24 Cell Battery Management System Kit
Orion 2 BMS - 24 Cell Battery Management System Kit
£ 960.77
£ 960.77

Drive Unit Bearing 6307/C3

https://shop.fellten.com/web/image/product.template/12768/image_1920?unique=9f57836

£ 6.00 6.0 GBP £ 12.00

£ 12.00

Not Available For Sale


This combination does not exist.


Share :
Terms and Conditions

Orders Dispatched Within 24 hours  - Excluding Weekends and Bank Holidays.

Worldwide Shipping
30 Days Return
Fast Delivery


The smaller of the two drive unit bearings. 35 mm bore, 80 mm outside diameter, 21 mm wide. Check which position you are replacing: the 6308 is the 40 mm bore bearing and the two are not interchangeable.

An SKF 6307/C3 open deep groove ball bearing with C3 internal clearance, for a Tesla drive unit rebuild.

The C3 in the part number is the part that matters. It specifies a greater internal clearance than a standard bearing, and it is what you fit where the bearing will get hot or where there is an interference fit on the shaft or in the housing. Both close the clearance up in service: heat expands the inner race faster than the outer, and a press fit squeezes the races directly. A standard clearance bearing in either situation ends up preloaded, runs hot, and fails early. A drive unit is both hot and press fitted, which is why it uses C3.

Open means no seals or shields, so it relies on the gearbox to retain lubricant and exclude dirt. That is correct for a bearing running in a drive unit's oil.

Replace bearings as a set where you can. If one has failed the others have done the same mileage, and a drive unit is not something you want to open twice.

Key specifications

Manufacturer partSKF 6307/C3
TypeDeep groove ball bearing, open
Bore35 mm
Outside diameter80 mm
Width21 mm
Internal clearanceC3, greater than standard
SealsNone, open both sides
Weight1 kg

Features

  • C3 clearance, correct for an interference fit at drive unit running temperatures
  • SKF, a manufacturer whose bearings can be specified with confidence
  • 6307/C3 is a standard designation, so it is dimensionally interchangeable
  • Open, for running in the gearbox oil

Compatibility

For Tesla drive unit rebuilds, and any application calling for a 6307/C3 bearing.

Do not substitute standard clearance for C3. If the original was C3 there was a reason, and a standard bearing in its place will run preloaded and fail early.

Fit it properly. Press on the race that is an interference fit, never through the balls. Driving a bearing on by its outer race to fit an inner race interference is how a new bearing is destroyed before it turns.

Work clean. Anything that gets into a bearing during assembly stays in the gearbox.

In the box

  • 1 x SKF 6307/C3 bearing

Downloads

No document is published here. SKF publish full data for this bearing series and we can point you to it.