A brass hose barb, 1/4 inch BSP male thread to an 8 mm barbed tail. Used on the oil pump feed in a Tesla drive unit conversion.
Adapting a drive unit's oil circuit to plumbing you can actually buy means converting its ports to a standard thread and a standard hose size. This fitting does that at the 8 mm end of the system.
Brass rather than aluminium for an oil fitting. It machines a clean thread, it does not gall against a steel or aluminium port, and it tolerates the heat of a gearbox oil circuit without losing torque in the joint.
Key specifications
| Part | BARB1/4-8 |
|---|---|
| Type | Hose barb adapter |
| Thread | 1/4 inch BSP male |
| Barb size | 8 mm |
| Material | Brass |
| Typical use | Drive unit oil pump circuit |
| Weight | 0.02 kg |
Features
- Converts a 1/4 inch BSP port to 8 mm hose
- Brass, which will not gall in an aluminium or steel port
- Barbed tail, for a clamped hose joint that holds under heat cycling
Compatibility
For 1/4 inch BSP ports taking 8 mm hose, commonly on a drive unit oil pump circuit.
Check whether your port is BSP parallel or tapered before fitting. A parallel thread seals on a washer or O ring at the face and should not be wound in with PTFE tape; a tapered one seals on the thread and should be. Getting that the wrong way round is the usual cause of a weeping fitting.
Use a proper hose clamp on the barb, and use oil rated hose. A cooling hose on an oil circuit swells and softens.
In the box
- 1 x brass barb fitting, 1/4 inch BSP to 8 mm
Downloads
No document is published for this fitting. For the exact thread form or dimensions, contact us.