Tesla Diagnostic Port Adaptor Cable OBD II - Post Sept 2015 Model S X
Terms and Conditions
Orders Dispatched Within 24 hours - Excluding Weekends and Bank Holidays.
Tesla Diagnostic Port Adaptor Cable OBD II – Post Sept 2015 Model S/X
Gain access to a variety of information about your Model S/X.
- Battery capacity.
- Battery voltage.
- Drive-train output.
- HVAC data etc.
A few apps are available that will make use of the OBD-II module diagnostic cable, will then read this data then display it accordingly.
Find Your OEM Connector.
The connector is located behind the cubby front centre. This can be taken off by pulling in a downwards direction.
Please don’t attempt this unless your are sure you know what to do.
CAUTION Please completely shut down your car before connecting this cable to the existing wiring. The complete shutdown can take up to 15 minutes. you can find information in your cars manual on how to perform a shut down on the vehicle.
Cable not suitable for Model S/X Pre Sept 2015.
Application software And Hardware.
You will need both a OBD-II adapter and software to be able to read and display the information.
Apps currently available.
ScanMyTesla (Android)
TMSpy (Andriod & IOS)
Please use an ELM327 / STN11100 compatible OBD-II Bluetooth adapter and the required cable for your vehicle.
Try to make sure you use a high quality adapter that supports the ST command set. For help with ODB-II adapter selection check the application software for information.
Please note. Connecting any equipment to your vehicle is done completely at your own risk. Zero EV will not be held responsible for damage caused to your Tesla. You are solely responsible for checking for any damage to the supplied cable before use. On receipt and before every use on the vehicle.